WARNING Couldn’t connect to API (Error connecting to 192.168.1.133: No route to host). WARNING Couldn’t connect to API (Error connecting to 192.168.1.133: timed out). WARNING Disconnected from API: Timeout while waiting for message response! : ‘Outdoor WiFi Signal’: Sending state -53.00000 dB with 0 decimals of accuracy : ‘Outdoor Humidity’: Sending state 37.14160 % with 1 decimals of accuracy : ‘Outdoor Pressure’: Sending state 1001.65967 hPa with 1 decimals of accuracy : ‘Outdoor WiFi Signal’: Sending state -52.00000 dB with 0 decimals of accuracy : ‘Outdoor Humidity’: Sending state 37.16406 % with 1 decimals of accuracy : ‘Outdoor Pressure’: Sending state 1001.65625 hPa with 1 decimals of accuracy However, when the DS3231 alarm is triggered, the. I believe I need to reset my microcontroller (by momentarily pulling the RST pin low) when the RTC alarm signal goes from high to low (the SQW pin on the DS3231). : Got temperature=23.6☌ pressure=1001.7hPa humidity=37.2% I'm trying to use a DS3231 RTC to wake my ESP8266 at a specific hour, minute and second. : ‘Outdoor battery voltage’: Sending state 4.11100 V with 2 decimals of accuracy : ‘Outdoor battery voltage’: Got voltage=0.27V : ‘Outdoor WiFi Signal’: Sending state -54.00000 dB with 0 decimals of accuracy (Message skipped because it was too big to fit in TCP buffer - This is only cosmetic) : ‘Outdoor Pressure’: Sending state 1001.65283 hPa with 1 decimals of accuracy : ‘Outdoor Temperature’: Sending state 23.56000 ☌ with 1 decimals of accuracy INFO Successfully connected to 192.168.1.133 The ESP might not be connected to WiFi yet (Error connecting to 192.168.1.133: timed out). INFO Starting log output from 192.168.1.133 using esphome API # Set this to the IP address of the router. …as per code and logs below.Ī very simple setup but can’t figure out why I can’t reconnect. The sensor update interval is 10s, deep sleep run duration is 30s (so should be plenty of time for the unit to recover and resend sensor values within the 30s window) and a deep sleep duration of 3 min. Without any deep sleep configured, the unit successfully provides sensor values every 10s but as soon as I configure the deep sleep it never re-connects to the esp8266 via wifi. It’s a simple setup with my esp8266 with a BME280 with pins D0 connected to RST. My esp8266 isn’t able to recover from deep sleep via wifi.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |